Page 768 - 2006 HARLEY FLSTCI SERVICE MANUAL

2-119

Figure 2-146. Rear Turn Signals: All But FLSTC
1 2
2006 Softail: Chassis

1
3
6 2 Figure 2-147. Rear Turn Signal Routing: FLSTSC
Screw and washer Turn signal mount Turn signal 5 4 3 Wire clip (left) Left turn signal wiring Cable tie Right turn signal wiring Wire clip (right)

s0617x8x 1. 2. 3. 10945 1. 2. Clip 3. 4. 5. 6.

See 8.22 TAIL LAMP: FLSTSC/FLSTN for FLSTSC tail
Route rear turn signal wiring as See Figure 2-144. Carefully place the fender into posi- tion. Install fender supports using hardware and brackets See Figure 2-143. Install nylon fastener (3) into electrical 1 2 3
See Figure 2-144. Install fender support (7) using wire
of fender support to connect turn signal (3) and mount
See Figure 2-146. Install screw and washer (1) to inside
mounting fasteners (1). Do not tighten fender mounting
retainer plate (6), fender mounting bracket (5) and fender

bracket fasteners at this time. Figure 2-147. shown. Install cable tie (4). shown. Tighten to 21-27 ft-lbs (28.5-36.6 Nm). Connect the harness at connector (1) [7]. Connect negative battery cable. 11WARNING 1WARNING After installing seat, pull upward on front of seat to be sure it is in locked position. While riding, a loose seat can shift causing loss of control, which could result in death 11WARNING 1WARNING Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) Check turn signal and lamp operation. Tail lamp connector cover

ASSEMBLY lamp installation. See INSTALLATION box (2) and fender. or serious injury. (00070a) Install seat. Fastener Clip

HOME 1. (2). 2. 1. 2. 1. 2. 3. 4. 5. 6. 10734 1. 2. 3.