Page 10 - B8773-AEW-XX-XX-PP-A-0001_[P4]_Contractors Manual
P. 10

1.1 Overview




       •  Domino’s  standard  is  a  single  glazed,         •  Aluminium  shop  fronts  are  to  be  polyester
          aluminium shopfront,  powder  coated  to               powder  coat  finished  to  colour  RAL  7043
          Traffic Grey RAL 7043.                                 Traffic Grey, and incorporate an aluminium
       •  All  window  frames,  stallrisers, and  fascia         entrance door fitted with full length handles
          board to be finished in RAL 7043 Traffic Grey.         to both sides, heavy duty letter box including
       •  Hand  painting  of  existing,  incorrectly             draft  flap/seals,  and  suitable  lock.  For  lock
          coloured,  aluminium shopfronts  is NOT                details  refer  to  Ironmongery  schedule.  The
          acceptable.                                            door  handles  are  to  be  finished  in  a  white
       •  Spray  painting  of  an  existing  aluminium           plastic material RAL 9010 to provide a ‘warm’
          shopfront  on site, even by a professional             surface as required by Part M.
          company, is NOT recommended.                       •  Contractor    must    ensure    that    aluminium
       •  Timber shopfronts   should always be repaired          sections    specified    for    door    frame    and
          as necessary and properly prepared before              door construction are sized to accept
          being re-painted to match RAL 7043 Traffic             specified  lock  components.  Especially  a
                                                                 75mm headrail on the drivers door.
          Grey              D R A F T
       •  All  shop  front  works  are  subject  to  Local   •  Where  masonry or concrete  rendered
          Planning Authority approval for appearance             surfaces  require  painting,  refer  to  DPG
          and materials of construction.                         Property  Dept  for  further  guidance  if
       •  All  works  by  contractor  must  comply  with         necessary.
          the  relevant  planning  consent (obtained         •  A  powered  door  operating  mechanism
          by others).                                            to  comply  with  ADM/Disabled  Regs,  is  not
       •  The  Principal  Contractor  is  to  be  responsible    normally  required.  However,  if  it  is,  it  will
          for  all  works  associated  with  removal  and        be supplied and installed by a specialist
          disposal of existing shop fronts, preparation          company.  It  will  require  a  13A  fused  spur
          of  structural  opening  to  receive  new  shop        above  the  ceiling  above  the  door.  It  will
          front,  and  design,  supply  and  installation        also  require  a  flat  panel  approx  150mm
          of new shop front. The design should utilise           high at the head of the door to mount it on.
          aluminium or timber sections, of appropriate           This  will  be  visible  through  any  top  light  on
          size and lengths such that it is sound and fit         the doorframe and must be appropriately
          for its purpose.                                       finished on both sides if visible from outside.
       •  All  works  must  comply  with  appropriate
          Building  Regulations, and  in  particular Part
          M Access to and Use of Buildings, and Part K
          Protection from falling, collision and impact.














       1.1                         Shopfronts - Overview                                 3 February 2016
   5   6   7   8   9   10   11   12   13   14   15