Page 12 - geneO X

Place the supplied screw on the top of the screwdriver tip and align in below the threaded insert in the button of the cradle. Insert the screw and twist it clockwise to tighten the connection. (Fig. 11). Be careful not to damage the screen while doing so! Verify that the cradle is locked in place.
Step 3 – connecting the handpieces:
Warning: Handpieces should be connected only when the system is turned OFF and the Power supplyis
not connected to an electrical outlet.
Have the back of the system facing you to unscrew the middle screw (identified in Fig. 12A) in the left- side back cover, using the supplied screwdriver.
Once unscrewed, simultaneously press the top and bottom clips of the left side back cover to be able to remove it altogether. The uncovered panel reveals female type connectors to which the handpieces would need to be plugged into (identified in Fig. 12B).
Note: The top-most female connector is disabled in this model, you may use any of the other three connectors.
Fig. 11
Fig. 12A Fig. 12B
Identify the male type connector at the end of the electrical cord of each handpiece. Hold the connector with the bumps on its circumference (Fig. 12C) directed at the matching dents in the female type connector and plug it inside all the way through until a “click” sound is heard. The insertion should be effortless if directed correctly (see Fig. 12D for the correct direction, Fig. 12E for depiction of well- connected handpiece).
Fig. 12C
Fig. 12D
12