Page 405 - Installation Training Binder FIT1-3
P. 405
Double Check– “Measure Twice, Cut Once!”
Take plenty of time to check all measurements again
If anyone in installation team has a question about measurements,
take the time to check them again
If the Liner is cut incorrectly it will equate to lost revenue and customer
dissatisfaction
D. Cutting the Liner
1. Cut Liner using 10” shears or a standard utility knife with a new blade
using a straight edge as a guide (Figure 14)
HINT:
Make cuts slightly inside of lines to insure a tight fit
Cut slowly and accurately
Make all through cuts on the same side and center of the stanchion
Figure 14
E. Fitting the Liner
1. Pull liner to original position adjacent to rack
2. Slide liner under rack (Figure 15)
3. Pull across evenly
4. Check all stanchions for proper fit (Figure 16)
1
No more than / 16” between all stanchions and liner
Fit should be tight and consistent
Figure 15 Figure 16
EnviroGuard 800-206-9884 Fax 909-624-1772 www.egsintl.com
11/07 rev. A Condor-Plus System Retrofit Installation Setup Instruction - 6 -
