Page 331 - CRESTRON HOME OS-3

Add or Remove a Lighting Load from a Scene

A scene can contain all devices that are located in a room or only a few devices. A scene can also
contain a lighting load that is located in different rooms in the house.

To add or remove a lighting load from the scene, follow these steps:

NOTES:

l The DALI protocol allows ballasts to be added to multiple DALI groups.
l Do not add multiple DALI groups to a scene if the DALI groups control a common ballast.
This will cause unpredictable lighting control when a scene is recalled and unreliable
feedback of the light levels in the user interface.

1. Tap the wrench button next to the lighting scene name. The scene configuration screen
opens.
2. Tap Add/Remove Loads. The Add/Remove Loads dialog is displayed.
3. Select a room from Select Room Below and then tap the check box next to the lighting
loads that should be controlled in the lighting scene.

4. Tap Save to save any changes or Cancel to discard the changes.

NOTE: Adjust the lighting scene as necessary. Refer to the "Configure a Lighting Scene"
section above.

Product Manual — Doc. 8525Z Crestron Home™ OS • 331