Page 334 - CRESTRON HOME OS-3

Configure a Shade Scene

A shade scene may be configured and tested after it has been added to the system. Use the List
of Scenes menu to select a shade scene for configuration.

To configure a shade scene:

1. Tap the wrench button next to the shade scene name. A notice is displayed stating that
the shade scene will be recalled upon entering the scene configuration dialog box. Tap OK
to display the dialog box or tap Cancel to cancel. The scene configuration screen opens.

2. Tap Add/Remove Loads . The Add/Remove Loads dialog is displayed.
3. Select a room from Select Room Below and then tap the check box next to the shade that
should be controlled in the shade scene.

NOTE: The shades can be from the same room or from different rooms in the house.

4. Configure the shade scene:
l Raise or Lower: Tap to raise or lower the shade incrementally.

l Full Open or Full Close: Tap to open or close the shade fully.

NOTES:

o Shade loads may also be adjusted using the shade motor controls or using
keypads configured to control the shade motors.
o The icon to the left of each shade load shows the percentage that the shade
group is open in real time.

5. Tap Save to save any changes or Cancel to discard the changes.

334 • Crestron Home™ OS Product Manual — Doc. 8525Z