Page 754 - CRESTRON HOME OS-3

Configure the Generic Relay-Controlled Device
Tap the Setup tab to configure the relay controls.

Operation Mode:

l Momentary: Momentary relays are used to turn a relay on and off for a set duration.
Select 1 Momentary Relay to toggle the relay between the on and off state. Select 2
Momentary Relays to have one relay enable the on state and the other relay enable the off
state.
l Digital Input: Digital inputs are used to monitor the device state.

Select 1 Digital Input if the device uses one sensor to monitor the on and off state. Select 2
Digital Inputs if the device uses two sensors to monitor the on and off state; one sensor to
monitor the on state and the other sensor to monitor the off state.
l Latching: Latched relays are used to turn a relay on and off and remain in the selected
state until an inverse command is sent.
l Pulse relay (Seconds): Enter how long the momentary relay should be closed (seconds).
The time can be set between 0.1 and 3 seconds. The default is 0.5 seconds.

NOTE: The Pulse relay (Seconds) field is not shown when the Operation Mode is set to
None or 1 Latched Relay.

Relay/Digital Input Configuration:

Product Manual — Doc. 8525Z Crestron Home™ OS • 737