Page 759 - CRESTRON HOME OS-3

NOTES:
l To enable the Open All and Close All functions and to display the garage door status in
the Crestron Home OS user interface, every garage door in the system must utilize at
least one sensor to monitor the garage door position. When one sensor is used, the
sensor must monitor the closed position of the garage door.
l The following configurations are not valid selections:
o None
o 1 Latched Relay
o 1 Momentary Relay, 1 Digital Input that monitors the opened state

Tap the Setup tab to configure the garage door.

Pulse relay (Seconds): Enter how long the momentary relay should be closed (seconds). The time
can be set between 0.1 and 3 seconds. The default is 0.5 seconds.

NOTE: The Pulse relay (Seconds) field is not shown when the Operation Mode is set to None
or 1 Latched Relay.

Seconds required for door to open: Enter the typical time (seconds) that it takes for the garage
door to open or close. This is used to stop the transition state when the garage door does not
reach a monitored position. The default is 20 seconds.
Operation Mode: Select the number of momentary relays and the number of digital inputs (for
example, VersiPorts).

NOTE: Certain garage door configurations do not provide adequate feedback to the control
processors. As a result, garage door feedback may not be provided to the customer in the

742 • Crestron Home™ OS Product Manual — Doc. 8525Z