Page 756 - CRESTRON HOME OS-3

2. Configure the digital input(s).

NOTE: If 2 Digital Inputs was selected, repeat these steps for both digital inputs.

a. Tap the digital input icon ( ) and then tap the gear button .
b. Select the hardware connection where the relay is connected and then tap OK.

c. Sensor Monitoring: Tap the On or Off button to select the state that the sensor is
monitoring.

NOTE:Sensor Monitoring is not displayed if 2 Digital Inputs was selected in
Operation Mode. An entry for On and an entry for Off is provided in the
Relay/Digital Input Configuration menu.

d. Sensor State: Tap the Contacts Are Open or Contacts Are Closed button to select
the state of the sensor contacts when Sensor Monitoring is set to On or Off.
e. Enable Pull-Up Resistor: Tap the Enable Pull-Up Resistor check box to enable the
pull-up resistor.

Product Manual — Doc. 8525Z Crestron Home™ OS • 739