Page 813 - Med Plaza and Cancer Center

PROPRIETARY AND CONFIDENTIAL DRAFT 28/Feb/03

4.4 Master Alarm Breakout P.C. Board
Chapter 4: Removal, Replacement, and Adjustment Procedures

4.4 Master Alarm Breakout P.C. Board

Tools required: 5/32" hex wrench
Needle nose pliers
Screwdriver

Removal

1. Using a 5/32" hex wrench, unlock the front panel (A) (see figure 4-5 on
page 4-14).

Figure 4-5. Master Alarm Breakout P.C. Board

SHOCK HAZARD:
Turn off the power supply in the alarm, and leave it off during the
installation or replacement of any component or sub-assembly. Failure
to do so could result in personal injury or equipment damage.

2. Turn the power switch (G) to the OFF position.

3. Note the positions of the wiring at the connectors (I) for the source
equipment.

Page 4 - 14 MedPlus TotalAlert™ Alarm Network Operation and Maintenance Manual (man291ra)