Page 234 - 2018 Allstar Performance Parts and Equipment Catalog
P. 234
TOOLS & PIT EQUIPMENT
Toe Plates Set-Up Plates
Aluminum plates simplify Set-up plates are used for
setting of toe-in and toe-out. squaring and stringing chassis to ALL10660
Plates fit against outside edges ALL10117 ensure accurate chassis set-up
of tires. Using two tape by eliminating wheel and tire
measures (sold separately), differences. Plates are 1/2"
measure the distance front thick and can also be used
and rear, between plates. when setting bump steer or
The difference in tape checking axle tubes for straightness. Sold each. ALL10662
readings is the toe setting. ALL10660 ..... 5x5, 7" x 28"
Deluxe plates have radiused ALL10119 ALL10662 ..... Wide 5, 12" x 28"
edges, slots for narrow and wide tape measures and
are 9" tall x 23" wide to work with vehicles with smaller Set-Up Stand
wheel openings. Standard plates are 1/2" thick, 11" tall Before tire and wheel are
x 32" wide and work well for vehicles with larger wheels removed, measure distance from
and wheel openings. Set of two plates.
center of hub to the ground. Remove
ALL10117 ...... Standard the tire and wheel, replace with the
ALL10119 ...... Deluxe set-up stand and adjust accord-
ingly. Adjustments can be made
16 Ft. Tape Measure with car at exact ride height
ALL10675 with the wheel and tire out of
16' x 3/4" blade has fractional the way. Sold each.
markings every 1/8" for quick ALL10664 ..... 5x5
reference. ALL10666 ..... Wide 5
Set-Up Tool ALL10668
Toe Gauge ALL10118
Check toe quickly and Tool replaces the front coil-over shock assembly to sim-
easily. Allows one person ulate range of front suspension movement for checking
operation and the ability bump steer and roll center. Hex head, threaded shaft
to check front and rear raises and lowers suspension to simulate racing condi-
toe dimension from the front tions. Jam nuts can be positioned to limit rebound and
of the car without removing tool. compression. Not designed to support total vehicle
Adjust stop against front sidewall of weight, only suspension components.
tires, slide tool to rear sidewall and the difference is the
amount of toe out. Tool adjusts to measure from 49" to a Upper Ball Joint Wrench
maximum width of 89". ALL11190
Wrench is designed to
Caster Plate ALL10752 remove and install common screw-in upper ball
Not sure if you turned your wheels the joints that are 1.900" wide (ALL56214).
same amount each time when adjusting
caster settings on your race car? Unless you
have expensive turn plates, you’re never
certain, until now. This quick reference gauge positions
under the upper ball joint nut, with markings facing up,
to easily view. Place a mark on the shock body or fabri-
cate an indicator to use as a reference point.
Ground Clearance Indicator
ALL10725 Hudson O’Neal Photo: John Berglund
Determine how close the frame is to the
ground on the race track. These unique
kits feature an aluminum bracket that
rivets to the frame with an adjustable
plastic wear rod. Sold each.
Replacement Part
ALL10726 ..... Wear Rods, 4-Pack
Don O’Neal Photo: John Berglund
232 www.allstarperformance.com