Page 36 - Router Boss Manual

With the centering bit positioned on the mark,
align the left-hand sliding bar cursor at a convenient
point over the white story board insert and make a pen-
cil mark along the outside edge. (It’s easy to make a
mark here on the white story board and easier to see,
especially if your shop lighting isn’t the best. The Rout-
er Boss’s cursors are also notched so you can make a
pencil mark on the aluminum face of the box beam and
leave the scales installed. )
Make pencil marks along the outside edge of the cur-
sor. You’ll also use this same edge when realigning the
cursor to make your cuts. (Note - the sliding bar was
moved slightly here to better show the pencil mark.)

Move the centering bit to the other layout marks,
marking the storyboard at each setting. However, you’re
only half done and this is where we introduce the sec-
ond set of settings for the pin boards.

Begin by turning (rotating) the socket board so the
same end is against the base plate, but with the “A”
face now against the sliding bar. Again align the
router centering bit with each marked pin cen-
terline, but this time, mark the right-hand
story board.

36