Page 37 - Router Boss Manual
P. 37

Cutting the Matched Sockets
                                                                                           Positioning pins at 0
             With both story boards marked,  you’re ready to                               degrees
        cut  the  sockets  boards. To  make  the  socket  cuts,  the
        variable angle guide rails should be set to “zero” (refer
        to page 22 for full details on how to do this).













































             Install  a  dovetail  bit  in  the
        router, then use one of the pin board
        pieces to set the router depth stop.  Cut
        the sockets using the left-side storyboard marks. Be-
        cause the sockets are a straight cut, you can somersault
        the boards and use the same set of storyboard marks to
        cut both ends.









             Once you’ve cut the sockets in one end, somer-
        sault the boards end-for-end (DO NOT CARTWHEEL)
        and cut the sockets in the other end. The pattern will run
        the same way on both ends of the boards.





                                                                                                                  37
   32   33   34   35   36   37   38   39   40   41   42