Page 65 - Router Boss Manual
P. 65
Turn the power feed hand crank to the next cursor
or DRO reading and reposition the router plate so it
rests against the front half of the right wing and the
back half of the left wing. Make sure the router is clear
of the stock, then turn it on, pull it towards you and cut
to the stop. Then push the bit back out of the cut and
clear of the stock.
Rotate the router plate back to the previous posi-
tion against the wings (front half left, back half right),
then make the next stopped cut. We’ve now cut the first
full pin.
Turn the power feed hand crank to the next set-
ting (2” center), rotate the plate against the front half of
the right wing and the back half of the left wing, then
make the next cut. (NOTE: With practice, you can use
the router to remove any excess left between the pins
by using the hand power feed to move the stock and cut
along the line. This will save you chisel work later. Just
be sure to keep the router plate firmly against the guide
wings and the stop.)
65