Page 581 - Chief Architect Reference Manual

Window Specification Dialog

each unit in a mulled unit. When this box • Select To Sheathing Layer to recess the
is checked, a single wall opening with window to the wall’s sheathing layer.
one header for the entire unit is produced.
3 Specify the Mullion Depth for the
casing between the components of a
mulled unit, measured from wall surface.
Positive values move the mullion surface Not Recessed
towards the wall center; negative values,
away from it. Only available when a mulled
unit is selected.
• Specify the Inside depth of the mullion Recessed (to Main Layer)
on the interior surface of the wall.
• Specify the Outside depth of the mullion
on the exterior surface of the wall.
Recessed to Sheathing Layer
4 The Recessed into Wall options allow
you to recess the selected window or Vertical Stacking - Specify the
mulled unit into a wall, away from the 5 window Level that the selected window
exterior surface. Only available if the is placed on. Not available for mulled units
window or mulled unit is in a multi-layered or window symbols. See “Window Levels”
wall. Check Recessed to enable these on page 570.
options.
6 A preview of the selected window
• Select To Main Layer to recess the displays here. See “Dialog Preview
window to the wall’s Main Layer. Panes” on page 42.

Casing Panel

The CASING panel is not available in the
Window Symbol Specification dialog.

581