Page 26 - Wave Wrap™

WAVE WRAP™

Installation

Waves and Fins Cleaning Material

Lower Side Wheels
The wash material fill for the lower side-wheels are the same as the Belanger, Inc. Wave Low Side
®
Washer . This section will assist in the installation of the lower side-wheel wash material.
Note: Do not install any wash material until all equipment has been installed, turned on and
checked for hydraulic, pneumatic and water leaks.

1) Install bottom drive wave and seat counter-bore over the drive plate.
Counter Bore

2) Locate the 24” Fins™. Place 4 pieces over pins on bottom drive Wave™. One piece of wash
material should straddle the opening on each Wave™.

3) Install next Wave™ with slot opposite the opening on the previous one.
4) Repeat steps 2 and 3 until 9 waves have been stacked on top of the bottom Wave™ (total of 10
rows of wash material).
5) Press down on the top Wave™ stack to seat the wash material and verify the bottom Wave™ is
on the drive plate.

24 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL864