Page 38 - Low Side Washer

LOW SIDE WASHER

Maintenance

Torque Plate and Electric Motor Replacement

Remove Motor Gearbox assembly

6) Remove the torque stud retainer pins and washers from above the gearbox torque plate
mounting holes. This will now allow the motor gearbox to be removed by pulling the
assembly straight up and off of the torque studs and off the wheel shaft.

Move the motor gearbox assembly to a work surface and turn it over to expose the bottom of the cover
and the cover mounting plate if so equipped. You will need a work surface such as a table or a bench
available to allow for disassembly of the gearbox torque plate.
If the assembly does not have a cover, proceed to step 8
7) The cover base can be removed by removing the three fasteners on the cover mount plate.
Once the cover mount and cover are removed, this will allow access to the bottom of the
gearbox / torque plate assembly.

8) Using a 5 mm hex head socket; remove the four fasteners and torque plate and separate
mounting ring to expose the mounting holes on the gearbox.

9) Remove the torque stud retainer pins and washers from above the gearbox torque plate
mounting holes. This will now allow the motor gearbox to be removed by pulling the
assembly straight up and off of the torque studs and off the wheel shaft.

34 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL858