Page 40 - Low Side Washer
P. 40

LOW SIDE WASHER


             Maintenance


             Torque Plate and Electric Motor Replacement

                Reinstall Motor Gearbox assembly

                3)  Locate and secure washers and the newly supplied  zinc  cotter pins into place. This will
                    secure the gearbox into position.













                4)  Feed the wiring up through the cover and through the plastic fitting on the motor junction
                    box. Make sure to tighten the fitting properly to prevent any water intrusion.













                5)  Once the wire is feed back into the junction box, secure the terminal block back into position
                    using the Phillips screw. Be careful not to crimp  or crush any of the existing wiring.
                    Reconnect the wiring leads to the previously tagged motor leads to maintain  the  proper
                    wiring positions.














                6)  Replace the junction box cap while being careful not to crimp or crush any of the existing
                    wiring.
                7)  Once the motor gearbox unit is properly secured into position, power can be turned back
                    ON.
                8)  Verify wheel rotation prior to running any test vehicle through the system.









              36            Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681         1MANUL858
   35   36   37   38   39   40   41   42   43   44   45