Page 10 - Tunnel Support Components

TUNNEL SUPPORT COMPONENTS

Introduction

Basic Overview

The components covered in this manual are typically the most critical parts of the Belanger, Inc. Car
Wash System, it is imperative that you understand the concepts used in their designs and they MUST be
installed correctly.

Component Placement
Note: See site-specific prints and drawings for dimensions and actual tunnel placement of all
components.
Traditionally it is advised to locate and install the Motor Starter Panel and the Output Controller first so
that the utility contractors can get their work out of the way.
The Motor Starter Panel and the Output Controller are the “BRAINS” of the system. They do the
thinking. They house the following components:
• Motor Starters • Main Disconnect • System Output Boards
The Hydraulic Unit and Pneumatic Panels are the “HEART” of the system. They pump life into the
tunnel components. The Pneumatic Panels should be mounted on the wall very close by.

All of the above components are designed to be installed in a traditional “Back Room” and comes with a
standard utility package that will accommodate most back rooms. Your VAR can acquire any
additionally required utility materials.

CAUTION

No communication cables are to run through the same conduit as any 3 phase
wires due to possible interference.

CAUTION

It is recommended that a licensed electrician is contracted to perform all electrical installations.

Disconnect and lockout electrical power before servicing any equipment!

Always wear safety glasses when performing maintenance on any equipment.

Note: See Provided Prints for details on all electrical, hydraulic and pneumatic connections
(incoming and outgoing).

8 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL760