Page 53 - DuraTrans XD® Conveyor

DURATRANS XD® CONVEYOR

Maintenance

Powder Coating Maintenance
Just as washing your car is important for removing dirt and grime, your powder coated equipment
needs to be given a regular wash to keep it looking good. In conjunction with a regular
maintenance program, your powder coated equipment requires special care to maintain its
durable finish, and is a smart way to protect your investment.
The effects of atmospheric pollution, general dirt, grime and airborne salt deposits can all
accumulate over time and should be removed at regular intervals. As a general rule powder coat
cleaning should take place every six months. In areas where pollutants are more prevalent,
cleaning programs should be carried out on a more frequent basis i.e. every three months.

Cleaning Procedure

Cleaning should start at the time the product is installed, ensuring that construction materials such
as concrete, plaster and paint splashes are removed before they have a chance to dry. Failure to
remove these materials at an early stage will require the use of aggressive cleaning materials and
techniques with potential damage to the powder coated surface.
The best method of cleaning is by regular washing of the coating using a solution of warm water
and non-abrasive, pH neutral (pH 5 -8) detergent solution.
1. Spray the powder coated surface with a garden hose to rinse off any loose dirt or debris. DO
NOT use a power washer or high-pressure water as this can wear and cause harm to the
powder coated surface.
2. Using a mild detergent and warm water clean the powder coat surface with a soft cloth,
sponge, or a soft natural bristle brush. DO NOT use water heated to a temperature above
140° F, as this can wear and cause harm to the powder coated surface.
3. Rinse the sponge or soft brush as needed to prevent any abrasive debris from collecting on
the cleaning surface.

4. Thoroughly rinse the powder coat surface with a garden hose after cleaning it to rinse off and
remove all detergent residues.

Tips & Warnings
· Over-cleaning or excessive rubbing can do more harm than good
· To prevent marring, make sure cleaning sponge, cloth, etc., are grit-free
· Abrasive materials such as steel wool, abrasive brushes, etc., can wear and harm finishes
· Do not scour painted surfaces
· Do not under any circumstances use strong solvents such as thinners, aggressive alkaline, acid or abrasive cleaners
· Do not use a power washer, high-pressure, or water heated above a temperature of 140° F, as these can wear and cause harm
to the powder coated surface
· Always use a test surface first
· Use nothing stronger than white spirits to assist with stubborn stains. Cleaning with white spirits should be carried out in shade
and during cooler temperatures using a soft cloth and gentle wiping only. It is also recommended that a small non-visible area be
tested initially to ensure that no color change or damage will occur
If you have any questions or concerns regarding how to clean powder coat equipment
please call Belanger® Technical Support / Aftermarket Group for additional assistance.

1MANUL010 Belanger, Inc.® * PO BOX 5470 *Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 49