Page 17 - Photo Eye (Basic)

PHOTO EYE (Basic)

Maintenance

Routine Procedures

Daily
• Start every washday with a “Test Wash” to insure proper operation of all equipment.
• Check overall performance for any abnormalities on the first few vehicles washed each day.
Weekly
• Check alignment of photo-eyes, and verify that light on receiver is operating.

• Clean lens on photo-eyes using a mild non-abrasive cleaning solution, to eliminate any buildup that may
have occurred during daily operations.
• Inspect photo-eye frame for cracks, and verify anchor bolts are tightened.

• Inspect wiring and junction box for moisture and corrosion.

Note: Dielectric grease is good for detouring corrosion
Monthly
• Wash component down with a good degrimer such as Tide laundry detergent and hot water.
Quarterly
• Scrub down aluminum portions of the component with a fine steel wool such as S.O.S. pads and wash
with good degrimer such as Tide laundry detergent and hot water (whenever using steel wool on
aluminum, always follow the grain to prevent scratching the finish).

Replacement Parts
Wind Door Kit # PE 105131
Part Number Description

1ELECT-SN220 Receiver for enter switch assembly
1ELECT-SN215 Emitter for enter switch assembly
1ELECT-SN230 Amplifier for Wind Door entry switch
1ELECT-RL250 Relay socket for entry switch
101490 Driver side photo eye stand weldment assembly
101491 Passenger side photo eye stand weldment assembly
1ELECT-EN350 Enclosure for entry switch assembly

Entrance Kit # PE 105128
Part Number Description

1MANUL585 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 15