Page 14 - Wind Doors

WINDDOOR

Installation

Lagging Frame to the Floor

1) Once the equipment is properly positioned, check for level and plumb on all dimensions.
2) Shim the Wind Door™ appropriately (shims not provided), drill and lag the Wind Door to the floor
using the 1/2-13 x 3-1/2” cement quick lag bolts provided.
Note: There are a total of four 1/2” lag bolts provided (two for each leg). Install the lag bolts
diagonally on the detail plate.

CAUTION

Belanger, Inc. does not recommend the use of a Clear Wind Seal Door at exit end of facility
where no employee is present to assist door opening if failure occurs. This may cause damage to
vehicle and/or equipment.

12 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL874