Page 60 - FreeStyler® Maintenance Manual
P. 60

®
            MAINTENANCE


            Chapter 2 Preventative Maintenance


            Pumping Station Float Valve Seal Replacement Kit #105884


               Positioning the Float Valve for Operation
               In order for the Float-Valve Assembly to work correctly, the Float must be centered (left-to-right)
               as shown below.
















               To center the float valve (left to right), follow the steps below.

               1)  Loosen the Lock Nut shown below and rotate the Float Arm until it is properly centered.

                                                     Lock Nut











               2)  Tighten the Lock Nut.

               General
               The Float Valve should be inspected at regular intervals to ensure that it works freely and has not
               been  clogged  by  residue  from  the  solution  in  the  tank,  especially  if  it  has  not  been used on a
               regular basis.
               Minor leakage is acceptable between the Stem and Bonnet when the valve is operating but not
               when  the  valve  is  closed.  If  such  leakage  becomes  unacceptable,  the  Disc  and  Teflon™  Cup
               should be replaced.






                                         Minor leakage is acceptable here











             2-32             Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681               1MANUL222
   55   56   57   58   59   60   61   62   63   64   65