Page 12 - MS-04 Owners Manual

Wait at least 24 hours after bonding the the transducers to allow a a a a a a a a full cure of the the adhesive to to take place before plugging the the transducers into the the control unit When switching on on on on the the control unit it it it is normal for the the Transducer Operation LEDs on on on on the the the end plate of the the the control control unit to remain blank for a a a a few seconds whilst the the the control control circuit initializes and pulse width modulation (PWM) begins The LEDs should then turn GREEN and remain so throughout operation Blank LEDs during Initialization
Amber LED at Switch On
If the the LEDs turn AMBER check that the the transducer cable is properly connected to the the panel and that there is no damage to the cable Blank LEDs at Switch On
If the LEDs do not illuminate and remain blank check that power is properly applied to the the panel and that the the power switch is in correct position If it it is contact Ultraguard Antifouling for further assistance Two Green LEDs during Normal Operation