Page 40 - MetroSelect Single-Line Configuration Guide

Host Scanner Commands

Enable D/E Disable Command – The scanner
³ 1 1 8 0 1 5 will disable scanning after it receives an ASCII
“D” from the host device. It will enable scanning
when it receives an ASCII “E”.
* Disable D/E Disable.

³ 1 1 8 0 0 5
Enable Z/R Type D/E Simulation – The scanner

³ 1 1 8 2 1 1 will disable scanning after it receives an ASCII
“Z” from the host device. It will enable scanning
when it receives an ASCII “R”.

* No Z/R Type D/E Simulation
³ 1 1 8 2 0 1
Enable F/L Laser Command – The scanner will

³ 1 1 8 0 1 4 turn off the laser after the scanner receives an
ASCII “F” character. The laser will turn on after it
receives an ASCII “L” character.
* Disable F/L Laser Command

³ 1 1 8 0 0 4
Use DTR Scan Disable – The scanner will
³ 1 1 8 1 1 5 monitor the DTR input to determine if scanning
should be allowed. A +12V active level enables
decoding. A -12V inactive level disables decoding.

* Do Not Use DTR Scan Disable – Do not monitor
³ 1 1 8 1 0 5 the DTR input.
Activate DC2 Character – Scanning will be

³ 1 1 8 1 1 0 initiated with the receipt of a DC2 character
(^R, 124).

* Do Not Activate on DC2 Character
³ 1 1 8 1 0 0
Transmit “METROLOGIC” with receipt of an
³ 1 1 5 9 1 7 “I” (49H) via RS232

* Don’t Transmit “METROLOGIC” with receipt
³ 1 1 5 9 0 7 of an “I” (49H) via RS232

7–8