Page 721 - Wurth Total Catalogue

rADiATor seAl hp Protection for all modern, high

performance, cross-flow cooling
systems.

Seals leaks to a maximum of 0.1 mm in the
area of cylinder head gaskets and hose
connections.
• Dirt strainers in cooling circuit do not get
clogged.
Eliminates evaporation loss in heat
exchangers, heater valves, radiators
and auxiliary devices.
• Enhances operating reliability and
protects against engine damage due to Air-Con
loss of coolant.
Product effective until the next anti-freeze
change.

Micro-fine synthetic particles provide sealing
effect. Exhaust
Description Contents Art. No. Pack Qty.
Radiator Seal HP 150 ml 5861 500 150 12 No need to drain product.

Areas of Use:
• In event of microscopic leaks in the Cooling
cylinder head gaskets and hose
connections.
• In event of evaporation losses in the
cooling system.
• Can be used as a preventative measure
each time the anti-freeze is changed. Steering
• Can also be used on closed cooling
systems.
• Suitable for all conventional antifreezes
and coolants.

Application: Trans
With the engine warm introduce directly to
cooling system. Only put into expansion tank
if coolant flows through it. Then allow the
engine to run for at least 10 minutes until the
thermostat opens and you notice the heater Intake
starting to give off heat. Then turn off the
engine, re-check the coolant level and top up
if necessary.

Dosage:
Fuel
Sufficient for 10 litres of coolant.

AUS. pub. 01/14 © Please note: Wurth Radiator Seal is not a conventional radiator sealant. Oil
Conventional radiator sealants must not be used on modern cross-flow cooling systems
since the strainers will get clogged; this can result in radiator failure and thus damage to
the engine.

08 0566