Page 1142 - Foton Workshop Manual - Aumark (BJ1099)
P. 1142

34-112                    AXLE AND PROPELLER SHAFT - DRIVING GEAR


                                                      (j).    Install the driving gear assembly.




















                                                      (k).    Install the pinion flange assembly.




















                                                      (l).    Tighten the nut.
                                                              Torque : 217N•m


















                                                      (m).  Measure the driving gear startup tightening
                                                              torque with a Torque wrench.
                                                              Startup Torque : 1.5~2.6N•m
                                                          NOTICE:
                                                      Don't unscrew the nut to reduce the startup
                                                      Torque.
                                                          NOTICE:
                                                      If the startup Torque exceeds the limit, replace the
                                                      driving gear bearing sleeve. (Refer to "Chapter
                                                      34 Axle & Transmission Shaft - Driving Gear,
                                                      Overhaul") If the startup Torque is below the limit,
                                                      take the following actions.


                                                                                                     Page 1142
   1137   1138   1139   1140   1141   1142   1143   1144   1145   1146   1147