Page 1143 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - DRIVING GEAR 34-113

(n). Further tighten the nut.
Torque (increase) : 5N•m
Torque (max.) : 217N•m

(o). Measure the driving gear startup tightening
torque with a Torque wrench again.
Startup Torque : 1.5~2.6N•m
NOTICE:
If the startup Torque is still below the limit, repeat
Steps (n)-(o) until it reaches the required range. If
the nut Torque exceeds the maximum value while
the driving gear startup Torque is still below the
limit, replace a new driving gear bearing sleeve.
(Refer to "Chapter 34 Axle & Transmission Shaft -
Driving Gear, Overhaul")

9. Check the engagement mark of the driving and driven gears (Refer to "Chapter 34
Axle & Transmission Shaft - Rear Differential Assembly, Checking & Adjustment")
10. Install the rear differential assembly (Refer to "Chapter 34 Axle & Transmission
Shaft - Rear Reducer Assembly, Replacement")
11. Install the rear main reducer assembly (Refer to "Chapter 34 Axle & Transmission
Shaft - Rear Main Reducer Assembly, Replacement")
12. Top up the main reducer gear oil (Refer to "Chapter 34 Axle & Transmission Shaft -
Rear Main Reducer Gear Oil, Replacement") 34

Page 1143