Page 1462 - Foton Workshop Manual - Aumark (BJ1099)

44-6 WIPER AND WASHER - WIPER AND WASHER

CHECKING

1. Check the washer pump assembly
(a). Connect the battery positive terminal (+) to
Terminal 2 of the washer pump assembly
connector.
(b). Connect the battery negative terminal (-) to
Terminal 1 of the washer pump assembly
connector.
(c). Check whether there is fluid coming out
of the washer pump assembly outlet.If no,
replace a new washer pump assembly.
NOTICE:
While connecting the pins, ensure the normal
voltage of battery and the normal contact of pins.
DANGER:
Complete this process in short time, or it may
damage the washer pump assembly.
WARNING:
During operation, add proper amount of washer
fluid into the tank.

2. Check the front wiper switch and the front
washer switch
(a). Measure the resistance between the
terminals and perform conduction tests.
MIST Close
OFF ON
PULL
OFF REAR
LO Standard:
HI
Intermittent
Front Washer
Low speed Pin Resistance
Switch
High speed
OFF All ≥ 1 MΩ
INT 3 - 4 ＜ 2 Ω
LO 2 - 3 ＜ 2 Ω
1 2 3 4 5 6 7 8 9 10
HI 1 - 3 ＜ 2 Ω
fuwx44004
MIST 1 - 3 ＜ 2 Ω

Rear Washer Pin Resistance
Switch

OFF All ≥ 1 MΩ

ON 7 - 5 or 6 ＜ 2 Ω
If the resistance is out of the specification,replace a new combination switch assembly.
(Refer to"Chapter 37 Steering Mechanism - Combination Switchassy, Replacement")

Page 1462