Page 1507 - Foton Workshop Manual - Aumark (BJ1099)

AUDIO SYSTEM - ANTENNA ASSEMBLY 45-23

(d). Use an adhesive gun to apply black
polyurethane glass adhesive to the
specified area.
NOTICE:
Do not apply excessive glass adhesive.If the
glass adhesive is applied to the non-specified
area due to carelessness, wipe away the glass
adhesive with a clean cloth before it gets dried.

(e). Install the antenna assembly
• Before the installation, peel off the
isolation paper from the double-sided
adhesive tape of the antenna assembly.
• Place the antenna assembly with suckers 45
and install by aligning with the antenna
assembly locating pins.
• Press lightly along the edges and when
necessary correct the position by a
scraper.
• Fix the antenna assembly with tapes and
wait for the adhesive to consolidate.

5. Check for water leakage and repair
(a). After the consolidation of the glass adhesive, apply water pressure from the outer
side of the vehicle. Check and ensure that the inside of the vehicle is free of water
leakage.
(b). In event of internal water leakage, wait for the water to dry and then apply the glass
adhesive.
(c). Remove the tapes.

Page 1507