Page 851 - Foton Workshop Manual - Aumark (BJ1099)

TRANSMISSION - TRANSMISSION ASSEMBLY 21A-9
REPLACEMENT (4WD)

1. Park the vehicle on level ground, engage the park brake and shift in N position
2. Disconnect the negative cable of the battery (Refer to "Chapter 18 Starting &
Charging - Battery, Replacement")

3. Unscrew the drain plug at the bottom of the
transmission, drain the transmission oil
NOTICE:
• Before draining, ensure the ventilation plug is
clear.Unscrew the drain plug and drain the oil
when the engine is hot, in order to drain as
much gearbox oil as possible.
• When draining the gearbox oil, recycle it with a
special container and dispose it as required.
• After the lubricating oil of the transmission is fully
drained, install the oil drainage plug, in order to
prevent missing installation.
Torque:65~78N•m

4. Disconnect the connector of the reverse lamp
switch
21A

5. Remove the transmission shifting system (refer to "Chapter21 Transmission - Transmission
Shifting System, Replacement")
6. Remove the clutch cylinder (Refer to "Chapter 22 Clutch - Clutch Cylinder, Overhaul")
7. Remove the transmission shaft (Refer to "Chapter 34 Axle & Transmission Shaft -
Transmission Shaft Assembly, Overhaul")
8. Remove the transfer case assembly (Refer to "Chapter 23 Transfer Case - Transfer Case ,
Replacement")

Page 851