Page 877 - Foton Workshop Manual - Aumark (BJ1099)
P. 877
TRANSMISSION - SECOND SHAFT ASSEMBLY 21A-35
NOTICE:
• When installed in the gear, the needle bearing shall be no higher than the gear end, or
check the installation position or replace the bearing.
• When installing the needle bearing, shake it and check for missing needle. Replace it in
case of any damage.
• During installation, apply some lubricant to the needle bearing, to avoid wear caused by
dry friction.
(b). Install the third gear.
15. Install the third/fourth gear synchronizer
assembly
(a). Install the third gear synchronizer ring.
21A
(b). Install the synchronizer gear sleeve, gear
hub and sliding block.
Page 877
