Page 352 - Foton Workshop Manual - Tunland (AT)
P. 352
04-206 DIAGNOSTICS - ENGINE CONTROL SYSTEM
NO>Intermittent trouble exists.
2 . Confirm whether there is fault code related to fuel in fuel indicator sensor?
(a) Ignition switch: OFF.
(b) Disconnect the battery negative cable.
(c) Disconnect fuel hydrous indicator sensor connector E19
04
(d) Disconnect connector E01 of ECM.
(e) Use a multimeter to measure the resistance
between the pin 1, 2 of fuel hydrous indicator
sensor connector E19 and the pin 47, 44 of
ECM connector E01 respectively.
Standard resistance
Multimeter connection
Standard value
pin
E19（1）- E01（47） ＜10 Ω
E19（2）- E01（44） ＜10 Ω
(f) Use a multimeter to measure the resistance
between the pin 1, 2 of fuel hydrous indicator
sensor connector E19 and the ground
respectively.
Standard resistance
Multimeter connection
Standard value
pin
E19（1）- ground ＞ 10 MΩ
E19（2）- ground ＞ 10 MΩ
Is the inspection result normal?
YES>To step 3.
No > Maintain or replace the harness.
3 . Replace fuel in fuel indicator sensor
(a) Replace fuel in fuel indicator sensor.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Check whether DTC exists.
Is the inspection result normal?
Page 352
