Page 485 - Foton Workshop Manual - Tunland (AT)

DIAGNOSTICS - ENGINE CONTROL SYSTEM 04-339

(f) Use a multimeter to measure the resistance
between the pin 1, 3, 4 of intake mass flow
sensor connector E07 and the ground
respectively.

Standard resistance

Multimeter connection 04
Standard value
pin
E07（1）- ground ＞ 10 MΩ

E07（3）- ground ＞ 10 MΩ

E02（4）- ground ＞ 10 MΩ

Is the inspection result normal?
YES>To step 7.
No > Maintain or replace the harness.

7 . Replace EGR valve
(a) Replace EGR valve.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Check whether DTC exists.
Is the inspection result normal?

YES>Replace EGR valve.
NO >To step 8.

8 . Replace ECM

(a) Replace ECM.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Verify that no DTC exists and the data are normal.

Page 485