Page 344 - Foton Workshop Manual - Sauvana

12B-54 ENGINE MECHANICAL - ENGINE ASSEMBLY

(d). Apply a small amount of engine oil to the
journal, the bearing hole and the protruding
point of the intake/exhaust camshaft.
(e). Install the intake camshaft.
(f). Install the exhaust camshaft.
NOTICE:
• When installing the intake/exhaust camshaft,
they shall be put down gently in horizontal
direction.
• When installing the intake/exhaust camshaft,
you shall adjust to make the spur of each cam
do not face down.

(g). Install the intake/exhaust camshaft according to the mark requirements.
NOTICE:
• If there is a direction sign on the camshaft, it cannot be interchanged while installing.
• I2/I3/I4/I5are used for the intake camshaftandE2/E3/E4/E5are used for the exhaust
camshaft.
• While installing, the arrow direction of the bearing cap should be turned to the crankshaft
belt pulley of the engine.

(h). From the middle to two sides, gradually
tighten the bolts of the bearing cap
of exhaust camshaft according to the
sequence shown in the figure.
Torque : 10N•m

Page 344