Page 345 - Foton Workshop Manual - Sauvana

ENGINE MECHANICAL - ENGINE ASSEMBLY 12B-55

(i). From the middle to two sides, gradually
tighten the bolts of the bearing cap of
inhale camshaft according to the sequence
shown in the figure.
Torque : 10N•m

12B

(j). Install the OCV valve, install the fixed bolts
and fasten them.
Torque : 10N•m
NOTICE:
• Avoid knocking in the process of installation,
and check whether the strainer filter is clean
and intact without obvious granules, whether the
O-ring is in good condition, and whether the seal
ring is scratched, or else the installation cannot
be implemented.
• Before installation, lubricate the O-type ring
with oil, and then push the OCV valve into the
mounting holes of the cylinder head carefully
till the mounting surface is connected with the
cylinder head, and at last, tighten the bolt.
• Clean the OCV valve with clean oil rather than oil of powerful solvent (e.g. gasoline), nor
can it be blew by compressed air. If OCV valve is pasted with oils except for the engine
oil, it should be cleaned promptly.

Page 345