Page 1204 - Workshop Manual - Tunland (2017)

11-16 ENGINE CONTROL SYSTEM - INTAKE MASS FLOW SENSOR

11 REPLACEMENT

1 . Switch off the ignition.
2 . Open the engine hood.
3 . Disconnect battery negative cable. (Refer to "Chapter 20 Starting and Charging
- battery, replacement (MT/AT)")
4 . Disconnect the intake mass flow sensor
connector.

5 . Screw out the intake mass flow sensor
fixing screw.

6 . Take down the intake mass flow sensor.

7 . Install the intake mass flow sensor.
CAUTION

• O-ring of the intake mass flow sensor
should be replaced.

8 . Tighten the intake mass flow sensor fixing
screw.
Torque:1.5 Nm