Page 1738 - Workshop Manual - Tunland (2017)

34-116 AXLE AND PROPELLER SHAFT - REAR DIFFERENTIAL ASSEMBLY

(c) Measure the thickness of the differential
bearing spacer.
If it exceeds the limit, replace a new spacer.
(Refer to "Chapter 34. Axle & transmission
shaft - rear differential assembly, overhaul")

(d) Ensure the distance between the main
reducer housing and the mounting end of the
differential bearing on the differential housing.

(e) Install the differential bearing spacer.

CAUTION
34
If no replacement, install it by left/right as
marked. Ensure the spacers on both sides have
the same thickness.

CAUTION

The thickness of the differential bearing spacer
should be 0~0.02mm greater than the distance
derived in Step (4).

19 . Install the Differential Bearing Cap
(a) Put 2 differential bearing caps in place as
marked.

CAUTION

Install them as marked.