Page 1736 - Workshop Manual - Tunland (2017)

34-114 AXLE AND PROPELLER SHAFT - REAR DIFFERENTIAL ASSEMBLY

15 . Measure the Gear Side Clearance between
Half Axle Gear and Planetary Gear
(a) Measure the gear side clearance between the
half axle gear and planetary gear with a dial
indicator.
Gear side clearance between half axle gear
and planetary gear:
If the clearance exceeds the limit, check the
end clearance of the half axle gear. (Refer to
"Chapter 34. Axle & transmission shaft -
differential assembly, check & adjustment")

CAUTION

Hold the half axle gear and the planetary gear
close to the differential housing, fix any of the
two gears and measure the central point of the
other gear surface. Ensure the head of the dial
indicator is vertical to the measured gear
surface. Measure all four gears at three or more
points on each gear.

16 . Measure the End Clearance of the Half
Axle Gear

34 (a) Measure the end clearance of the half axle
gear with a feeler gauge.

End clearance of half axle gear: mm

CAUTION

Keep similar end clearances on both sides.

17 . Install the driven gear.
(a) Check for damage and wear on the driven gear surface and repair or reaplcee it if
needed. (Refer to "Chapter 34. Axle & transmission shaft - rear differential assembly,
overhaul")
CAUTION

Replace the driving and driven gears in pairs. Repair it for minor damage. And replace
it in case of scratch, peeling, corrosion point, crack or overly wear.