Page 1739 - Workshop Manual - Tunland (2017)

AXLE AND PROPELLER SHAFT - REAR DIFFERENTIAL ASSEMBLY 34-117

(b) Tighten the retaining bolts of the differential
bearing cap.
Torque: 95～122 N·m

20 . Measure the driven gear runout.
(a) Rotate the driven gear by hand.
(b) Measure the runout on the mounting surface
of the driven gear with a dial indicator.
Standard: mm

If the runout exceeds the limit, replace a new
one. (Refer to "Chapter 34. Axle &
transmission shaft - rear differential assembly,
overhaul")

21 . Check the engagement mark of the driving and driven gears. (Refer to "Chapter
34. Axle & transmission shaft - rear differential assembly, check & adjustment")
22 . Check the pre-tension of the differential bearing. (Refer to "Chapter 34. Axle & 34
transmission shaft - rear driving gear, check")

23 . Install the Rear Cover
(a) Apply some sealant on the interface between
the rear cover and the main reducer and
install the rear cover in place.