Page 1833 - Workshop Manual - Tunland (2017)

TRANSMISSION（JC538） - TRANSMISSION ASSEMBLY 41-19

(b) Install the reverse lamp switch.
Torque: 30 ~ 35N·m

(c) Connect the reverse lamp switch connector.

16 . Top up the gearbox oil and tighten the filler
plug.
Torque: 30 ~ 35N·m

CAUTION

• Required gearbox oil (model):
GW-7,75W/90.
• Filling volume: 1.6L.
• Don't mix the gearbox oil of different
brands.
• When checking the oil level, ensure the
vehicle is level and the oil level is no lower
than 5mm from the bottom of the filler
plug.

17 . Connect battery negative cable. (Refer to "Chapter 20. Start & charge - battery,
replacement")
18 . Transmission grinding standards and tests.
(a) It shall be performed at approx. 1500 RPM, with the oil temperature no lower than 41
15oC and without load. It shall run no less than 15 minutes at the neutral gear and 20
minutes at any other gear.
(b) Check whether the shifting is smooth and the gears are completely engaged.
(c) When testing the transmission, there shall be no abnormal sound of friction or impact.
(d) The transmission shall have no leakage.
(e) After grinding, drain the gear oil used for grinding, thoroughly clean the interior of the
transmission and fill it with the gearbox oil as required.