Page 945 - Workshop Manual - Tunland (2017)
P. 945
DIAGNOSTICS - ENGINE CONTROL SYSTEM 04-259
(e) Use a multimeter to measure the resistance 04
between the pin 1, 3, 4 of EGR valve
connector E18 and the pin 29, 96, 66 of ECM
connector E01respectively.
Standard resistance
Multimeter connection
Standard value
pin
E18（1）- E01（29） ＜10 Ω
E18（3）- E01（96） ＜10 Ω
E18（4）- E01（66） ＜10 Ω
(f) Use a multimeter to measure the resistance
between the pin 1, 3, 4 of EGR valve
connector E18 and the ground respectively.
Standard resistance
Multimeter connection
Standard value
pin
E18（1）- ground ＞ 10 MΩ
E18（3）- ground ＞ 10 MΩ
E18（4）- ground ＞ 10 MΩ
Is the inspection result normal?
YES>To step 5.
No > Maintain or replace the harness.
5 . Check intake mass flow sensor circuit
(a) Ignition switch: OFF.
(b) Disconnect the battery negative cable.
(c) Disconnect intake mass flow sensor connector E07.
(d) Connect the battery negative cable.
(e) Ignition switch: ON.
