Page 1181 - Flipbook_SolidDesignSoutheast2020

Gravity Metal Detector System—Operator Setup Manual

1.9 Removing & Installing Display Panel

NOTE: It is important to follow these instructions when
removing or installing the display panel.

1. Loosen cover bolts (using 5mm Hex Key as supplied) in a diagonal pattern, 1‐2‐3‐4 until all tension is removed.

2. Be sure to follow this pattern until all bolts have completely loosened. This will ensure that the bolt retaining
O‐Ring will stay in place and the cover bolts will remain will the cover.
3. To remove, unplug Ethernet connector cable attached to main board.

4. To re‐install, plug display panel Ethernet connector cable to main board.
See diagram below for removing and installing the display panel.

3

1

2

4

Page 10 www.fortresstechnology.com