Page 13 - Linde - HMF/A/V/R-02 Hydraulic motors for closed and open loop operation

Torque transmission. PTO Through-Drive Motor

Based on a standard Series 02 variable hydraulic motor with single shaft end, the PTO Through-Drive Motor features two shaft ends
for torque transfer. This enables the hydraulic motor to be installed directly in the drive line without transfer gearbox, reducing
noise emission and fuel consumption. At the same time the overall efficiency increases.

B) PTO dimensions for HMV-02

Rated size 105 135 165 210 280
Z drive shaft profile 16/32, 19 t 16/32, 21 t 16/32, 22 t 16/32, 24 t 16/32, 27 t
in accordance with ANSI B92.1
D shaft diameter mm 31.2 34.51 36.05 39.27 44.05

L1 shaft end length-housing mm 30.1 16.2 -0.5 20.9 18
L2 usable spline length mm 41.5 31 31 44 47
L3 bearing stop mm 49.6 32 32.8 57.2 62

Continuous torque Nm 418 540 659 836 1122
Max. torque Nm 736 1068 1305 1654 2221

B) PTO dimensions PTO Through-Drive motor w. coupling flanges
For a direct installation into the drive line

13