Page 118 - Parker - Vacuum products

Catalog 0802-E Pressure Sensors
Technical Information MVS-201 Genius

Wiring diagram Sensor male pin out
M8 Pin #
1 Brown: 24VDC
4 2
2 White: Input; NPN (0VDC) / PNP (24VDC) 1
2
3 Blue: 0VDC
3
4 Black: Output; NPN / PNP Open Collector Output 4
3 1
201 Pin #
1 Red: Vacuum Solenoid Valve + V
B 2 Black: Gnd
3 Red: Blow-Off Solenoid Valve + V
4 Black: Gnd

Internal circuit

(Brown) +V (DC 10.8 to 30V) (Brown) +V (DC 10.8 to 30V)
(White) (White)
Suction/Break Command Input Suction/Break Command Input
Load 125mA + Max. +
Selection
Digital IN Max. Digital IN
Generator
(Black) OUT 1 - (Black) OUT 1 125mA -
Load
Main Circuit (Blue) OV + Vacuum or TR Main Circuit (Blue) OV + Vacuum or TR
CV-CK
1 (Red)
1 (Red)
MCA, CV,
Valve
Valve
2 (Black) - Solenoid 2 (Black) - Solenoid
3 (Red) + Break 3 (Red) + Break
CHF
- Solenoid - Solenoid
4 (Black) Valve 4 (Black) Valve
Connector for connection of solenoid valve Connector for connection of solenoid valve
Connection is finished when Convum is installed Connection is finished when Convum is installed
MC22
Output / Input NPN sinking Output / Input PNP sourcing
MC72
! Cautions Installation
The MVS-201 Pressure Sensor is designed to monitor pressure • Never insert an object into the pressure port other than an
and is not a safety measure to prevent accidents. appropriate fluid connector.
CEK
• Avoid short-circuiting the sensor. Connect the brown lead to
The compatibility of the sensor is the responsibility of the V+ and blue lead to 0V.
designer of the system and specifications.
• Do not connect the output lead wires (black / white) to the
Operating environment power supply.
CVXCEK
• Parker Sensors have not been investigated for explosion- • Outputs not being used should be trimmed and insulated.
proof construction in hazardous environments.
• Do not use with flammable gases, liquids, or in hazardous
MPS-23
environments.
• Avoid installing the sensor in locations where excessive
voltage surges could damage or affect the performance of
MVS-201
the sensor.
Operations
• Dedicate a power supply of 10.8 to 30VDC to the sensor
and set the ripple to Vp-p10% or less. Avoid excessive
voltage. Avoid voltage surges.
Generator
Accessories
• A small amount of internal voltage drop is possible. Ensure Error messages
the power supply minus any internal voltage drop exceeds Display Description Solutions
the operating load. Reset zero below
• Verify the operating media is compatible with the Err Zero reset error 3% of F.S.
Glossary
specified sensor. Check the chemical make-up, operating Er1 System error (Internal) Contact factory
temperatures, and maximum pressure ranges of the system Load current exceeds
before installing. CE1 Over current of Output 1 maximum 125mA.
• Installation of air dryer system is recommended to remove FFF Applied pressure exceeds Apply pressures within
moisture. –FF pressure range the rating of the sensor
B48 Parker Hannifin Corporation
Pneumatic Division
Richland, Michigan
www.parker.com/pneumatics