Page 402 - Wago_PCB_TerminalBlocksConnectors_Volume2_2015_US

Male Headers with 1 x 1 mm and 1.2 x 1.2 mm Solder Pins, THR (Through-Hole Reflow*)
6 Pin Spacing: 5.08 mm
400 MCS MIDI Classic
● THR male headers for reflow soldering in SMT production

● Available in tape-and-reel packaging for automated pick-and-place
assembly

● Also available in bulk packaging for manual placement

● Male headers may be mounted horizontally or vertically
● With coding keys

Technical data: 1 x 1 mm 1.2 x 1.2 mm

Pin Spacing 5 mm 5 mm Derating Curve
0.197 in. 0.197 in. 231-102/026-000 female connector
Ratings per IEC/EN 60664-1 IEC/EN 60664-1 with 231-432/001-000/105-604 male header
Overvoltage category III III II III III II Pin spacing: 5 mm / Conductor size: 2.5 mm “f-st”
2
Pollution degree 3 2 2 3 2 2 Based on: EN 60512-5-2 / Reduction factor: 0.8
Rated voltage 320 V 320 V 630 V 250 V 320 V 630 V Current in A
Rated surge voltage 4 kV 4 kV 4 kV 4 kV 4 kV 4 kV 45
Nominal current 12 A 12 A 12 A 16 A 16 A 16 A 40
Approvals per UL/CSA UL/CSA 35
Use group UL 1059 B C D B C D 30
Rated voltage 300 V – 300 V – – – 25
Nominal current UL 10 A – 10 A – – – 20
Nominal current CSA 10 A – 10 A – – – 15
The MCS MIDI connection system is UL 1977 approved and capable of up to 600 V for factory wiring. 10
5
Solder pin data:
Solder pin: length/width 2.4 mm /1 x 1 mm 0 10 20 30 40 50 60 70 80 85
Solder pin: drilled hole diameter 1.4 +0.1 mm Ambient operating temperature in °C
2-, 4-, 6-, 12-pole Conductor rated current
Solder pin: length/width 2.4 mm / 1.2 x 1.2 mm
Solder pin: drilled hole diameter 1.7 +0.1 mm

For other pin lengths, please contact factory.
Material data: MCS MIDI accessories: Pages:
Material group I
Insulating material Glass-fiber-reinforced polyphthalamide (PPA-GF) Separators 472
Flammability rating per UL 94 0V Coding keys 472
Lower/Upper limit temperature -60 °C / +100 °C Fixing elements 472
Contact material Electrolytic copper (E )
Cu
Contact plating tin-plated
MCS connectors are also available upon request with gold-plated or partially gold-plated contact surfaces.
Depending on the version requested, “item no. suffix . . . /010-000” is added to the “basic item no.”

MCS — MULTI CONNECTION SYSTEM includes connectors without breaking capacity in accordance with
DIN EN 61984.
When used as intended, these connectors shall not be connected/disconnected when live or under load. The circuit
design should ensure header pins, which can be touched, are not live when unmated.

Additional approvals and corresponding ratings can be found at www.wago.com. *For THR soldering, see page 405. **UL/CSA approval pending
For additional technical information, see Section 13.