Page 72 - Linde - VT1 Modular, modular system for LSC manifold valve plates
P. 72
5 | Assembly of System components. Preparation
Tie rods and cap nuts
First the selected tie rods are bolted together with the cap nuts. It must be ensured that the short threaded end of the tie rod is
screwed hand-tight down to the base of the cap nut.
Tie rods and cap nuts with VT1A pressure relief module / VT1B blanking plate
The selected tie rods with the bolted cap nuts are inserted in the existing holes of the VT1A pressure relief module or VT1B blanking
plate, as shown in the image. The tie rods with the bolted cap nuts are then guided through the existing holes in the expansion
modules (if present) and screwed into the VT1EE.
after selection of VT1A pressure relief module
Possible base plate or
expansion modules:
VT1EE, VT1EA, VT1EP, VT1ED
4x tie rod with cap nut size 19, tightening torque 86 Nm
after selection of VT1B Blindplatte
Possible base plate or
expansion modules:
VT1EE, VT1EA, VT1EP, VT1ED
72
