Page 130 - Condition Monitor User Manual

Viewing Measurement Data

• The ‘Line Voltage’ column indicates the Line Voltage Operating Condition at the time
of the measurement. If Line Voltage was not available at the time of the
measurement, this will be blank.

• The ‘Temperature’ column indicates the Temperature Operating Condition at the
time of the measurement. If Temperature was not available at the time of the
measurement, this will be blank.
• The ‘Humidity’ column indicates the Humidity Operating Condition at the time of the
measurement. If Humidity was not available at the time of the measurement, this
will be blank.
• The ‘Gas Pressure’ column indicates the Gas Pressure Operating Condition at the
time of the measurement. If Gas Pressure was not available at the time of the
measurement, this will be blank.

• The ‘Comments’ column shows a User-editable comment about the measurement.
Columns in the measurement list can be resized; to resize a column, click and drag the
edge of the column.

Figure 9-26 Resize Measurement List Columns

Note:
Take caution when re-sizing columns; it is possible to make the
column too small to see the values in the cells.

Note:
The measurement list can be re-sized by dragging the top edge of the
list up and down. When doing this, some of the data view may be
covered; use the scroll bar in the data view or change the
measurement list height to see the covered portions of the data view.

9.4.4. Summary View
The Summary View is the default data view in SMView. It shows summary results for
the measurement selected in the measurement list. To open the Summary View, select the
‘Summary’ tab. in the ribbon.

The ribbon will display the date/time, Operating Conditions and the comment of the
currently selected measurement.

The view is a simple table displaying the Summary Numbers and status for each input:

124
www.irispower.com