Page 1001 - 2006 HARLEY FLSTCI SERVICE MANUAL

45° 30°

3
Transmission sprocket nut Transmission sprocket
2 Figure 6-30. Transmission Sprocket Nut Final Tightening

1 Line scribed
d0353x6x 1. 2. 3.

With LOCTITE 6.3 1.14 REAR BELT DEFLEC-
Using locknut wrench, tighten sprocket nut to 60 ft-lbs

CAUTION Maximum allowable tightening of sprocket nut is 45˚ of counterclockwise rotation, after initially tightening to 60 ft-lbs torque. Do not loosen sprocket nut while attempt- ing to align the screw holes. Tightening too much or little may cause the nut to come loose during vehicle opera- See Figure 6-30. Scribe a line (3) on the transmission sprocket nut (1). Continue the line on the transmission Tighten the transmission sprocket nut an additional 35˚ Install lockplate over transmission sprocket nut so that two of lockplate’s four drilled holes (diagonally opposite) align with sprocket’s two tapped holes. See Figure 6-27. Install scre

(81.4 Nm) initial torque. tion, causing damage to drive components. sprocket (2) as shown. to 40˚ (45˚ MAXIMUM). tapped holes in sprocket (4). screws when you install the lockplate. The screws have LOCTITE patches. the screws can be re-used 3-5 times. mary chaincase leaks. DRIVE COMPONENTS. ALIGNMENT. Adjust belt tension. See 2006 Softail: Drive

HOME 5. 6. 7. 8. 9. 10. 11. 12. 13. TION. 6-18