Page 22 - i-Pilot Link Owner's Manual

GETTING STARTED

2 c. If you are using an Ethernet extension cable for your Eight Pin
installation, connect it to the i-Pilot Link from the i-Pilot Link Connector
Control Head. Hand tighten the Locking Collar. Cable
i-Pilot Link Cable from
NOTICE: The connectors are keyed to prevent Control Head
reversed installation. Be careful not to force the
connectors together.

Locking Collar

3 d. Route the i-Pilot Link Cable to the Ethernet port on

the Humminbird or to an available Ethernet port on i-Pilot Link Cable Locking Collar
the Ethernet Switch. i-Pilot Link Cable from
Control Head
NOTICE: The cable should be routed through an
established routing system on the boat, in an area
with minimal interference. Inspect the selected route
carefully to ensure that there are no sharp edges,
obstacles, or obstructions that may damage the cables.

e. Hand tighten the Locking Collar.

Power up the i-Pilot Link System

Follow these simple steps each time you power up your trolling motor for successful operation:
1 a. Connect trolling motor to power. 1a 1b

b. Deploy trolling motor into water.

NOTICE: i-Pilot Link startup varies slightly Power Cables
between trolling motor models. The i-Pilot controller,
in the Control Head, can communicate with the Deployed
remote when the motor is stowed, once the motor
and remote have power. When the motor is stowed,
remote buttons will be disabled.

22 | minnkotamotors.com ©2019 Johnson Outdoors Marine Electronics, Inc.